Filament roll holder

thingiverse

Here is a simple connector to create a filament roll holder using those leftover pieces of threaded rod from making your 3D printer. All you need to do is add four legs, each about 13 cm long, and a horizontal bar that can be as long as you want to hold several filament rolls at once. I added some circular bearings under the filament roll, but a cylindrical bearing should work just fine too. For the feet, I used some PolyMorph because it was quick and easy to flatten. Printer Settings: * Printer Brand: RepRap * Printer Model: Mendel self-made * Raft Options: Not applicable * Support Settings: No support required * Resolution: 0.4 mm is a good starting point, but you may need to adjust the resolution based on your specific needs Important Notes: * You may need to flip the model 90 degrees around the Y axis and scale it by 10% before printing. * Make sure to check the printer settings for any necessary adjustments before printing.