Filament holder

thingiverse

I Printed the Part from PLA. Four bearings, 625ZZ type, and four screws, M4 x 40mm with nut were used for assembly. At the bottom, a piece of rubber was glued in place. Print Settings: - Printer Brand: RepRap - Printer Model: Prusa i3 - Rafts: No - Supports: Yes - Resolution: 0.2 - Infill Percentage: 40% Notes: - Part one was printed with a resolution of 0.3, without support. - Part two was printed with a resolution of 0.2, also without support. - Part three was printed with a resolution of 0.2 and included support.