Filament Holder

thingiverse

I'm Using Wood to Build a Frame for an Ideal Filament Holder, Along with These 3D Printed Parts for the Shaft. 01/01/15 - Working to Print Out Part Plans to Finish and Upload Pictures on 01/03/15. 01/02/15 - I Notice That the Nut Fits into the Shaft Piece Just a Little Too Tight; I'll Fix the Design as Soon as Possible. 01/03/15 - Uploading "Shaft_Left_New" and "Shaft_Right_New", Which Should Fit a Bit Better Now. 01/03/15 - Some Small Setbacks, But I Plan to Be Finished Tomorrow for Now. 01/04/15 - Completed Printing Out Parts, Uploading Pictures. Instructions: Wood Pieces: Use Two 10" Pieces and Two 4" Pieces, Assemble Them Using Six Screws or Glue. In the 10" Pieces, Drill a 3/8 Hole Two Inches from Each End, Centered. Print Two Bolts and Two Nuts, Put Nuts in Right and Left Shaft Parts, Fasten the Shaft to the Frame with Bolts. You May Need to Sand Prints Depending on How They Came Out.