Filament Holder for Wistek IdeaWerk 150

thingiverse

This is a brand-new filament holder designed for the Weistek IdeaWerk 150 printer. I bought some BuMat filament several weeks ago, but was surprised to discover that it wouldn't fit into the factory spool holder. The newly printed holder has solved this problem completely. I want to apologize if you downloaded the first model I posted, as the hole spacing turned out to be slightly off. But these two new models are designed perfectly to match your printer's specifications. As for the recessed screw design, I haven't printed it yet, but since it's a remix of the original, the hole spacing is identical. I used 50% infill and five shells with an extrusion rate of 45mm/s when printing this holder without any support structures. Although the model came out fine, the initial few layers on one end of the stop didn't quite bridge well as they should have. As shown in the picture, the model on the left is my printed holder, while the other one represents the original factory part. Here are the installation instructions: First, take out the old spool holder using an allen wrench and carefully put aside the short screws that were in it. Now, replace it with the new holder by inserting the longer screws you'll find in the spare parts bag.