Filament-holder

thingiverse

This filament holder is designed to be used in conjunction with a bearing to make unwinding a spool of filament significantly easier on a threaded axle. A 22mm bearing is utilized to ensure the rolling motion is smooth and effortless, allowing the extruder to feed the filament directly from the spool without any hindrance. The outer diameter of the holder measures precisely 53.50mm, perfectly accommodating the Luxorparts filament roll that I had on hand. Dimensions and measurements are as follows: Outer diameter (to fit snugly into the spool): 53.50 mm Inner diameter (where the bearing is seated): 22 mm Print time for a standard setup (0.2mm layer thickness, 50% infill): 1 hour and 17 minutes Filament weight: 19g (approximately 2.41 meters of 1.75mm filament) Total required print area: 60.0 x 60.0 x 15.0 mm Feel free to modify this design as you see fit!