Filament Guide with TriangleLabs Filament Runout Sensor Bracket for Wanhao i3 / Monoprice Maker Select and Plus

thingiverse

I combined this [Filament Guide](https://www.thingiverse.com/thing:1598317) and [Sensor Bracket](https://www.thingiverse.com/thing:3758252) into an awesome frankenstein. Filament goes on the same path as it did with the guide and riser, but without the swivel. I do not use the spool holder on the gantry (I spool from a filament dryer mounted above the printer) so it might not work in that case. Maybe I should have put the sensor bracket below and not above the arm... oh well. This is built to hold the triangle labs filament runout sensor. I used this [youtube video](https://www.youtube.com/watch?v=t2xUmibefYs) as a guide for its installation and use along with my Raspberry Pi-based Octopi / Octoprint setup. This does need to print with support for the bracket. I used tree supports to the bed only and it worked perfectly. I used 25% infill.