Filament guide with Bowden tube (or not) twist in for 20x20

thingiverse

I needed a filament guide for the top part of my printer, so Thingiverse off I go.... Found https://www.thingiverse.com/thing:3950799 (from txt file) There original design file was not quite right for me, so I remixed (as you see in the side by side photo, then came up with my version, which is what i wished to have, something as a guide for a Bowden tube. The little notch is because not all Bowden tubes are the same diameter, so I have found from various purchases. Note. You may find this a bit delicate and if you move it from place to place it may become a bit loose, you could try to make it 1% bigger for a tighter fit. if you find it useful, then you welcome, enjoy your 3D printing. Working on a bottom version for the filament run out.....