Filament Guide tube clip

thingiverse

These new clips replace the original filament guide tubes on the rear of your FlashForge Creator 3D Pro printer, and probably other models too. You can use them to swap out broken factory clips or upgrade your current ones for a smoother printing experience. Say goodbye to cracking fingernails or using tools to dislodge stuck guide tubes. Simply push the tube onto these clips to secure it firmly in place or easily pop it off when switching filaments. These upgraded clips also move the filament tube further away from the printer's back and closer to the center of the spool, ensuring the filament stays free from tangles caused by being stuck behind the spools. Using these new clips means you'll need fewer printing adjustments. I found them to be very effective at holding filaments in place even with 25% infill prints made from PLA without any supports or a raft.