Filament Guide No Support Needed, Clip In, And Side Gap!

thingiverse

Hello! This is my filament guide remix. You don't need any supports, just put the "entrance hole" facing the bed, and its good to print! You can choose any printing settings, but I will include the ones I used as well. Also, I made so only manually the filament can go in, and out of the side gap, this way there is no risk of the filament coming out of the guide by itself, so you do need to put a little bit of a push to inset the filament through the side gap. When I printed, I didn't adjust the bed properly, so the pic shows that even thou it didn't start that well when printing, it did manage to end the print, and work as intended, so if you print and the pic is better than mine, post here in the makes section! -Printing setting on Ender 3 with a 0.4 mm nozzle, and Cura as a slicer- Layer height: 0.2 mm Wall Thickness: 1 Wall line count: 3 Top/Bottom Thickness: 1.36 Top layers: 3 Botton layers: 3 Top/Bottom patterns: ZigZag Botton Pattern Initial Layer: Concentric Alternating extra walls: on (for extra strength, even thou it doesn't need it :D) Enable Ironing: off Infill density: 15% Infill pattern: Gyroid (Because it is the coolest design pattern, and no one can change my mind about that :D)