Filament Guide for Snapmaker 2.0 A350 Enclosure

thingiverse

Designed for Snapmaker 2.0 A350 with enclosure to solve the problem of the filament jumping over to the "wrong side" of the Z-tower and getting stuck there. Rather than holding the filament, this filament guide addresses the direct problem of filament jumping over the Z-tower by closing the gap between the Z-tower and the top of the enclosure. Filament jumps are prevented without adding additional drag to the filament path. I used this design as an experiment with architectural forms and design for 3D printing. The decorative arch helps to reduce filament use and provide access for an Allen key to screw the tower on. Designed to be printed without supports.