Filament Guide for Prusa I3

thingiverse

A Custom Filament Guide for Prusa I3 printers specifically tailored for the Rework 1.5 EmotionTech model is now at your fingertips.\nMy personal printer happens to be a highly modified Prusa I3, to be exact an Emotion Tech version. \nThe two files BoulonPasseFile and TubePasseFile need to be resized up by 10 units. \nBelow you can see my carefully chosen Print Settings: \nFirst off, I chose a renowned Printer Brand in the RepRap family. \nAs you can tell from the below, the actual Printer I used is a highly refined Prusa I3 model provided courtesy of Emotion Tech. \nThe key to printing with ease and accuracy for this setup, lies not only in setting rafts correctly but it also plays an important part whether to set supports or no. In our case I went with No on Raft option, so your prints do come out looking neat and tidy right away; same story applies to Support - you see we didn't need any there either, due primarily because of my model being Emotion Tech one where things work differently than usual ones since this setup's Resolution had been dialed in at an impressively fine value 0.2.\nFinally as for how densely your model will be packed inside after printing that is known to the community worldwide: My current default choice stands firmly by 20% Infilled density always!