Filament guide ender 3 ptfe

thingiverse

I used esun PLA+ with the following settings: nozzle temp 220 °C, bed temp 60 °C, I printed at 60 mm/seg and first layer at 10 mm/seg. Set the part in cura as shown in the picture added. When you import to your slicer it will be rotated due design position in Fusion360. Note: I used the same bolts and nuts that are installed in the original spool (I removed de original spool as upgrade, but purchase the same bolts and t-nuts and you can install it) and to install you need to remove the side small cover of the rail, insert the guide half way, and reinstall the cover. It's a little tricky, but can be done.