Filament Guide and Sensor Case - Ender 3 and other

thingiverse

I build the Case for the Sensor and Remixed the Filament Guide an arm in. I use a three wire Sensor connected to Octopi. To close the Case i used four M1.7*6 Screws, but you can just "click" it on. If your Sensor doesn't trigger right, you can "calibrate" it by bending the Metalpiece up or down. There's also a LED.stl file, wich you can print in Translucent material so that you can see the Status LED a bit better. It isn't nessecary but i feel like it looks better. You can just leave the hole ther to see the LED. You should use Support for this. There are some edges, that i couldn't remove 'cause I used TinkerCAD to Create the Mix of Case and Guide. I hate TinkerCAD because you cant edit mesurements easily later.(or maybe i cant use it right). I wasn't able to Mix the Models in OnShape.