Filament Feeder CR10S Pro

thingiverse

This is a filament feeder which mounts easily on the filament runout sensor case of the Creality CR-10S Pro. You will be able to use the stock screws and the mounting is extremely straight forward. The only additional part you'll need is a short piece of PTFE tube (I used left-over Capricorn). This filament feeder ends the issues with filament flakes given that the filament path is very well defined. It is intended to allow mounting the filament holder on the side of the CR-10S Pro close to the base. I noticed in high speed printing with accelerations over 1200 mm/s2, that mounting the filament holder close to the base rather than on top of the printer allows increasing accelerations by another 10 to 15% with the same quality. This results from reduced vibrations and resonance of the gantry due to less weight far away from the base. Try it out for yourselves...Works beautifully.