Filament Dryer Box Pneumatic Push Fit Adapter

thingiverse

Made a few variations while i was in my model, I personally used the 35 degree version, there is a 90 degree (perpendicular mount) or more extreme 45 degree version. Used so i can run my filament out of my dryer box and route through PTFE tubing to my print head. On my Printer the filament run into its enclosure is not perfect. Push fit opening is about 9mm, or sized for a 1/8 pipe thread. Piece is not threaded, use the metal fitting to cut the thread as you screw it in. I use a 4mm-1/8 PTC-PC-M04-R01 Pneumatic push fitting, but you can use others. You know your printer. You MAY need support, I printed with the large round opening on the bed. Rotate and lay flat the models as needed.