Filament Clip

thingiverse

I am experiencing a minor issue with my printer, as it consistently prints the hole smaller than intended; however, I suspect this is due to its higher speed and temperature settings. To rectify the situation, I have simply enlarged the hole slightly to achieve the desired clearance. It appears that many others have encountered the same problem, and I hope sharing this solution will assist someone in the future. A drill bit was suggested as a possible remedy, but I consider this counterintuitive for a 3D printer. Fortunately, enlarging the hole has resolved the issue for me. The test was conducted on a Replicator 2(Sailfish) using 1.75 PLA filament. The original design can be found at CountSpatula's Thingiverse page: https://www.thingiverse.com/thing:224791