Filament Clip

thingiverse

Filament Clip to Secure the Filament on Its Roll After Removing It from the Printer! This ingenious tool works flawlessly every time. Before printing, make sure you load the correct STL file, as any errors in file selection can cause issues. To troubleshoot, I made some adjustments to the size of my model after receiving feedback that it didn't fit. Thankfully, the correction was straightforward. For optimal results, take a moment to review your Print Settings: Printer Brand: Ultimaker Selecting the correct printer model is essential; in this case, I'm using an Ultimaker 2. Opt out of raft support for this print by choosing "No Rafts." Similarly, disable any supports with the option "No Supports." Adjust the resolution to 0.15mm for a high-quality finish. Set the infill percentage to 15% for a good balance between strength and material usage. Additional Notes: For this specific project, I'm printing without raft or brim support. As always, I'm using PLA as my filament of choice.