Filament Catcher for Anycubic Kobra Neo/Go/etc.

thingiverse

Remix of Kobrac0mmander's original design. I measured the rails on my Anycubic Kobra Neo and made some adjustments to the "feet" in FreeCAD: - Height (depth from bottom of box to bottom of foot): 6MM - Width: 6.15MM for each foot - Space between channels: 13.7MM - Chamfered bottom edges (parallel to rail) for better fitment After removing the support material (required because the box overhangs the "feet"), it should snap into place on the rail and will even slide a bit so you can adjust the position. I believe this will work for both Anycubic Kobra Neo AND Go printers, and theoretically any printer with rails matching the above measurements.