Filament and Cable Guide Add-on Sleeve Flashforge Creator / Pro

thingiverse

This is an add-on to http://www.thingiverse.com/thing:735350, engineered to secure split loom (1/2" or stock Flashforge) covered wiring in place. The original design's small filler piece was deliberately omitted for this iteration. To ensure a flush fit, the hole nearest the sleeve for the mounting screw will require countersinking. A handheld drill bit was used instead of a motorized drill to avoid over-drilling. Clear 6mm PTFE tubing with Macroline fittings is preferred due to its transparent design, allowing users to visually monitor filament status. Simply print two units and secure them around the base and loom using zip ties.