FiishTank: 16x16mm FX805 Camera Mount

thingiverse

This is a custom camera mount designed specifically for the FX805 camera used on a 16x16mm stack drone build. I use this mount on my Fiishtank 2s project, which can be viewed at: https://rotorbuilds.com/build/8061. The camera was sourced from getfpv.com, where you can find the FX805 Micro FPV Camera with 5.8GHz 37CH 25mW VTX and Mounting Case. The V5 version of this mount is optimized for printing in SLS Nylon and I've had great results using 3dhubs.com's services. However, it may not be suitable for FDM due to the elevated base, so please let me know if you have any success with it. The V5 design eliminates the need for spacers and extra nuts to secure the mount to the quad, assuming an M2 tap is used to add threads. I'd like to extend a big thank you to fishpepper.de, where I found valuable information on building a 2s pepperfiish beast, including shopping list recommendations: http://fishpepper.de/2017/07/28/how-to-build-a-2s-pepperfiish-beast-shopping-list-recommendations/. Version History: V1 had a fitting issue due to being too tight. V2 was almost perfect but the roll cage was undersized. V3 introduced a 0.5mm offset on the rear rib for my polou vreg, raised the cam box slightly, and beefed up the roll cage significantly. The fit was good, but the camera box was slightly too deep. V4 reduced the camera box depth by 0.2mm, adjusted the angle supports, and added a hole to save weight. V4 had a snugger fit on the camera and is 0.2g lighter than V3.