Figure Stand Parts

thingiverse

These custom figure support arms are specifically designed for figures and kits that use a 3mm mounting hole, primarily Figma, Frame Arms, Frame Arms Girl, and Megami Device.\r\n\r\nThe arms are assembled using common 2mm hardware - 2mm x 8mm screw, 2mm nut, and 2mm washer, the same sizes as the Figma stand hardware. Additionally, a 3mm x 10mm steel pin is required to fit into the 'Figure Pin Connector' part and Pivot parts.\r\n\r\nBase connectors are available that fit Figma bases, Megami Device figure bases, Kotobukiya figure flight bases, and several generic bases with a 5mm connection, such as Stage Act bases.\r\n\r\nThe arm joints are sturdy enough to support larger figures even for flight poses. A Chitocerium Platinum figure with Master Grade Wing Gundam's Wings attached is shown, with an overall wingspan of 17 inches.\r\n\r\nWith branching, pivot, and 90-degree rotating parts, you can connect a single base mounting point to multiple locations on a kit. The Figma 'Strength' from 'Black Rick Shooter' is shown, which normally requires three Figma stands to hold; the base used in the picture was a prototype with added reinforcing ribs.\r\n\r\nStands can be printed in any color, such as Red Silk PLA for Frame Arms Girl or black for a less noticeable appearance. For Figma figures, using smaller bases and minimal length arms can reduce space requirements, allowing multiple figures to be placed close together.