FIghter Jet Throttle Grips for Logitech/Saitek Throttle Quadrant

thingiverse

For those of you who own a Logitech/Saitek throttle quadrant and want a fighter-jet style throttle, here it is. I suggest printing with the inner (flat) sides down to minimize supports required. You will need a hobby knife and a small pair of needle nose pliers or rotary tool to remove the supports from the interior of the throttle shaft. These should fit somewhat snugly down over the throttle levers, similar to the interchangeable grips that are included with the throttle quadrant. They also raise the grip level so that the throttle grips are significantly higher, so if you're only using two of the custom grips the third lever isn't in the way. The Center_Left grip can be used in combination with the Right grip as either a double throttle or triple throttle setup. Both grips should work on any lever, but the right grip should always slide down on the rightmost lever that you are using the custom grips on. Tolerances are WIP.