Fidget Hand Quintuple Spinner with 5xM14 hex nuts

pinshape

Here is a high-performance spinner used with one standard 608 skateboard ball bearing (22mm) in the center and five M14 hex nuts on the outside. You can also add optional M3 hex nuts (up to three per nut hole). The result is exceptional inertia, allowing for spins of around 30 seconds to over two minutes, depending on your bearing and spinner balance. This heavy-duty spinner provides an incredible gyroscopic feeling! The hole diameter is precisely 22.1mm to ensure secure bearing mounting. To fit the nuts, you can use a hammer and a flat surface or sand the nut holes with a small file if necessary. As long as the nuts are on the same flat surface, it's okay if they're not perfectly centered. Note that standard M14 nuts are 3mm higher than the spinner height. Ditch your pen clicker and start hand spinning right away! Print Settings Printer Brand: CEL Printer: Robox Rafts: Not Required Supports: None Resolution: 200 microns Infill: 40-60% Post-Printing Resize needed @ 101-102%