FFCP top lid overhang cable holder & heat keeper

thingiverse

I needed a solution to keep my extruder's overhang cable from chafing against the edges of the Flash Forge Creator Pro's Top Lid, so I came up with this design to hold the cable in place while also trapping heat at the same time.\nIt is simple to install and easy to remove.\nFor more information on preventing top lid heat escape, check out http://www.thingiverse.com/thing:1834128.\nPrint Settings\nRafts:\nNo rafts were used in this print.\nSupports:\nThe part requires supports for stability.\nInfill:\nThe infill density was set to 35% for added strength.\nNotes:\nABS plastic is recommended for its high strength, especially since the top portion is critical and needs to be robust. The design also includes small internal supports that can be removed once they're no longer needed, allowing a snug fit into the top lid edges.\nPost-Printing\nAfter printing, I used a Dremel tool and a pick to carefully remove any stubborn supports inside the part.