FFCP Nozzle level

thingiverse

After replacing the nozzle on the creator pro, I found that getting them perfectly aligned using the build plate to be unreliable. if the build plate is off level so will the nozzles. This part uses the X axes guide rails to support a cross section just under the nozzles. The alignment is then "nearly" perfect by letting the rest on the crossbeam and tightening them in place. The 100% infill is critical as you want the least amount of flex possible. Rigidity is key. I used PLA for this first one but plan on making a permanent version out of PA-CF. NOTE: Nozzles must be cold when aligning them as they will melt in the crossbeam otherwise.