Fettec Spike/Capacitor Shelf

thingiverse

This a simple design to use as a shelf to mount the Fettec Spike Absorber/Capacitor to on the the FPVCycle Glide frame. This part has an inner dimension of 22mm, so it may fit other frames as well. Fit tolerance is tight by design so that the part doesn't slide on the standoffs. Key with this print, is to print slow. Print settings: - Layer height = .16mm - Print speed = 20mm/s - Supports = Touching build plate - Support density = 30% - Infill = 50% I wrapped the TVS board/Capacitor in Kapton tape to keep the profile small. 16 gauge wire used.