Feron TL3020 LED upgrade conversion kit

thingiverse

Prehistory: Fluorescent lamp gone and I couldn't find a replacement in local shops. I considered throwing the lamp away, but decided to upgrade it to an LED lamp instead. The old lamp sockets had been removed along with the electronic block. I opened OpenSCAD software and started designing new things. Meanwhile, I purchased a 12V 24W power supply unit. I have some LED strips and wires on hand. So, I took out the PSU from its enclosure and made just an insulating holder. The PSU board was hot glued inside the holder as the holder was hot glued to the lamp. Several wires and one connector were soldered between the PSU and LEDs. Nothing complex. Three lines of LEDs (21 LEDs each) used in the upgrade are visible on photos. You need 2 LED holders and 6 clamps, which can be seen on the photo. Print Settings Printer: Wanhao Duplicator i3 Rafts: No Supports: No Resolution: 0.2 Infill: 25-50% Notes: Printed with ABS.