Fennec For V6 hotend

prusaprinters

Parts List:5015 Fan * 24040 10 fanM4 nuts * 2M4 bolts * 2 max length 20mm min 10mmM3 bolts (from stock machine) * 6: Two for mounting onto x carriage, 4 for mounting the fan Max is 12 mm in lengthM3 Heated Inserts *2OptionalBL touch, plus mounting hardware Printing tips:Supports: requiredFor the fan ducts, use the flat face on the top of the duct so that the duct stands vertically, other orientations can work, but it is more consistent this way Build guidePlace the two Heated inserts located on the edge of the mounting collar for the v6Remove everything from the x carriage, and mount the back plateInstall the hotend, and place the two m4 nuts into the little slots on the upper armsstart to screw in the M4 nuts into the holes on the top arm. Take the two fan ducts and place the slots around the head of the m4 boltsFor Bl touch: Take the cover plate and mount the Bl touch to the two holes make sure the connector for the bl touch is facing away from the hole in the center of the cover plateX offset: 45.55y offset: 2Your z offset is going to vary greatly, depending on hotend choice and your nozzle choice, a recommended starting place is going to -4.5take the cover plate and line it up with the back plate, Screw in the two bolts that line up with the 2 heated insertsMount the 40mm fan into the 4 holes on the front of the cover plate and screw until tightYou Can now adjust the fan duct height using the m4 boltsHave fun Printing