Female 120/240 Volt Plug Cover

thingiverse

This is a protective cover that goes over the male end of power cords, adapters, etc to safeguard the terminals. It will accommodate both polarized and non-polarized plugs and supports 15 and 20 amp plug configurations on 120 or 240 volts with grounding. NEMA Ratings: 5-15 5-20 6-15 6-20 Printer Settings: Printer: Da Vinci 1.0 Raft Settings: No rafts will be generated. Supports: No supports will be provided. Resolution: The resolution of the print is set to 400 Microns. Infill: The infill percentage is set at 10%. Print Notes: The cover should be printed face up. Post-Printing Steps: Test Fitting The initial tight fit of the spades can be alleviated by removing and reinstalling the cover. Alternatively, you can file down the spade areas slightly if needed.