Feet Upgrade for Transformers Combiners Wars Ultra Magnus

cults3d

After launching the earlier Maxmius Ambus armor set ( https://www.patreon.com/posts/59194111 ), it appeared that a fix for the ankles/feet was a common request. Hence, here's our shot to remedy that with this feet upgrade set: These work by having the stock feet fold back into the rear of his thigh, and then pegging these addon parts in their place. Being built around a ball and socket joint, this upgraded foot should afford enough ankle tilt and pivoting to make for more stability for display as well as some nice action poses. On the underside of these feet, a pair of 5mm booster ports have been designed in to allow for effect parts addons! And finally, of course, here are some shots of how this upgraded feet look like together with the earlier Maximus Ambus armor set! === ASSEMBLY === The attached assembly diagram shows the parts of this kit. The ball and socket bit have been sized to have a little tolerance as possible to allow for the tightest fit, so depending on the variances of your 3d printer, you may need to sand the socket portion slightly if things aren't going together well. === Hope everyone gets a kick (heh heh) out of upgrading your Ultra Magnuses (Magi?) with this kit = have fun putting him into poses which were nigh impossible with his stock feet! =) === This model is not to be uploaded or sold in any form and is intended for personal use only. Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/) Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog