Feet for bathtub side

thingiverse

The bathtub has outdated and fragile feet on its sides. I upgraded these with new parts that require two significant bolts for height adjustment. Print Settings: Rafts Any setting works fine. Supports No support is needed. Resolution 0.15 millimeters work best. Infill A 60% fill rate provides the best balance. Notes: The ABS printing process involves heating up to 220 degrees and using an 80-degree heat bed. Consider increasing the nut print to 102 percent for easier turning. Alternatively, removing the nuts from the heat bed while they're still warm will make them adjust properly to fit the bolt-thread.