Feather Tiny box

prusaprinters

<p>This is a very small box for the Adafruit Feather micro controllers. if you dont need space for a lot of electronics, this might be all you need.</p> <p>Hardware:</p> <ul> <li>M3 Flat head</li> <li><p>M2.6x5 button For mounting, There are 2 M3 countersunk holes in the bottom, I used these to mount slider blocks but could be used to screw it to any number of things.</p> <p>To bolt on the top, i used some M2.6x5 screws that i had from RC, partially because i had them, partially because they were adorable as all frig. i think a slightly more "standard" M2.5 would also fit. Not that that is a easy standard either.</p> <p>One thing i never went back to adjust that could be fine tuned is the clips on the side of the bottom to secure the board in without screws.</p> <h3>Print Settings</h3> </li> </ul> <p><strong>Printer:</strong></p> <p>LulzBot Mini</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div>**Supports:** No <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2</p></div>**Infill:** .2 <strong>Filament:</strong> N/A PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>My printer was able to bridge without supports. YMMV</p></div> Post-Printing ============= <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/0a/1d/79/64/ab/IMG\_20190413\_102817.jpg"/></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/10/43/5e/53/36/IMG\_20190413\_102810.jpg"/></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/4f/b8/19/0d/de/IMG\_20190413\_102854.jpg"/></p></p></p> Category: Electronics