Faucet handle

thingiverse

This part was built in response to necessity. The painters snapped the old one, so I had to come up with something new. It's made to fit onto the splines of the faucet shaft. To get the best results, print it rotated 180 degrees. If you don't rotate it, you'll need a longer screw and a washer - be careful not to mix up inch and metric sizes, as they're almost identical. Due to variations in printers, it's possible to end up with a very tight fit, so make sure you've got the right one before applying too much force. I used a clamp to press on the handle instead of trying to force it down with the screw. Print Settings Printer Brand: RepRap Printer: Anet A8 Prusa i3 clone Resolution: 0.25mm Infill: 40% Notes: The Material is ABS. Wall thickness was set at 2mm Post-Printing After printing, please share your photos or feedback.