Fatshark 25mW Transmitter case

thingiverse

I built this custom case and lid for my fat-shark 25mW transmitter, which was a major accomplishment for me. A big thing about this design is that it accommodates the antenna connector on the back, which often breaks off and sometimes even tears off the solder pads from the PCB. To insert the transmitter into the mounting rails, you'll need to remove the heat-shrink covering first. It's likely you'll also need to enlarge the hole where the antenna connector passes through slightly by drilling it out a bit. Just make sure it fits snugly and not too loosely, or durability will be compromised.