Fat Shark 600TVL Mount for Hovership

thingiverse

A simple mount solution for a 600TVL camera on your quadcopter is available, secured with screws at the back of the camera. Although slight adjustments may be necessary, this mount fits well around spacers and is held firmly by top and bottom plates. If you face oversized holes in your printed piece, utilize a 13/64 drill bit for a snug fit. Note that the camera is vertically offset to avoid fitting between top and bottom plates. For printing, consider using the "Lite" version due to its crash-resistant capabilities and potential for support elimination; full version may be stronger but depends on your frequency of crashes. Remember to print vertically on the build surface without laying it down, requiring minimal support. Lastly, ensure proper fit by adjusting 5mm pieces around spacers and using a drill bit to open up holes if necessary. The "Lite" version also has an undercut on top to prevent pushing up against the top plate, with pressure solely on bolt columns for stability.