Fat Happy Sitting Pot

thingiverse

NOTE: This design is licensed under creative commons non-commercial. This means you are not allowed to use this model for commercial gain. This means, but not limited to, selling prints of the model (such as on etsy), and selling prints of derivatives of the model. To print this, no supports are required and it sits flat on the print bed. To get the finish in the photo, sand it down to 600 grit, apply filler primer, sand down to 2000 grit, apply paint, and finally a top coat of lacquer. In response to a comment below, a 'trimmed' version has been uploaded which takes the bottom 0.5mm off for slightly easier printing and ensuring a flat base.