Faster Honeycomb Sample Spool

prusaprinters

I love Aikoly's design, but it takes a really long time to print… so I modified the original to remove the extruded honeycomb pattern and used modifiers to add it back in the slicer. It cuts 90-120 minutes off the print time.Each spool requires 2 parts: 1 top and 1 bottom (A for up to 100g or B for up to 200g).Slicer InstructionsLoad the model for the top or bottom part with two modifiers:top-no-pattern.stl with top-inside-modifier.stl and top-outside-modifier.stlbottom-a-no-pattern.stl with bottom-inside-modifier.stl and bottom-outside-modifier.stlbottom-b-no-pattern.stl with bottom-inside-modifier.stl and bottom-outside-modifier.stlMake sure both modifiers are sitting flat on the build plate and centered on the part.Set the print parameters for each modifier:Fill density: 15%Fill pattern: HoneycombBottom solid layers: 0Top solid layers: 0Print ParametersLayer height: 0.2mmFirst layer height: 0.2mmNozzle diameter: 0.4mmFill density: 10%NOTE: My print settings are derived from Prusa's 0.20mm SPEED default. Settings derived from a different profile may not produce the time savings mentioned above.