Fast Live Levelling Calibration 198mm x 198mm

thingiverse

Thanks to Tacblades for the original I've made the overall dimensions slightly smaller (198cm x 198cm) because Cura was saying it doesn't fit on my bed (maybe I should look into that lol) I also added a few more squares, to allow me to make more adjustments to the z-offset while printing. I'm using a BLtouch for bed levelling. I run the auto bed levelling feature, and adjust the wheels as needed. Keep doing this until you get it as level as possible. (OctoPrint is great for visualising this but not needed) After levelling/traming the bed using auto bed levelling, I then adjust the z-offset with a sheet of paper to get in the ballpark. I then use this print to further dial in the exact z-offset for the perfect first layer. Reduce or increase z-offset while printing (Tune > z-offset). Change the value for each square, and make a note of it. When you peel them off, you'll know which is best, and can then save that z-offset value to the printers memory (I'm using Jyers firmware) Print settings 0.4mm nozzle 0.2mm layers Print temp 200 Bed temp 60