Fast Dual Joycon Grip

thingiverse

If you really think about it, you don't need a Joycon grip that has the full 10 cm arm length to encase the Joycon entirely. If all you want to do is hold the Joycons together at a particular angle, then all you need is a short connector between them. Short connectors also print much faster than a full-sized model, of course: around 30 minutes at 0.2 mm layers and 50 mm/s. I have provided 10, 15, 20, and 25 degree (included angle) holders to keep two Joycons together. They slide in from the **top** of the Joycon, not the bottom as you would normally do. The indicator lights and reset button on the Joycons are visible and exposed, and the electronic connections at the bottom of the Joycon aren't touched and therefore won't be damaged by this print.