Fang with Nuts and Adjustable BLTouch Mount for Ender 3

thingiverse

This is a remake of this Fang, https://www.thingiverse.com/thing:3676132, made by jckz82 along with this one https://www.thingiverse.com/thing:4163490. I used Tinkercad for this re-design. This also includes an adjustable mount for the BLTouch V3.1 that attaches to the side of the Fang. I used the BLTouch bracket that comes with the Creality BLTouch kit as a guide when I designed the BLTouch mount. The following changes have been made from the original: - The width of the fang ducts has been reduced to allow for the addition of a BLTouch mount without increasing the overall width. Mounting holes remain the same as the original. - Holes for the nuts to mount the fans have been moved to a lower location, providing more strength. - A guide has been added to the Fang to direct wires from the BLTouch up to the wiring harness. - Mounting holes have been added for the BLTouch bracket. Important note: Use M3x8mm socket head bolts and nuts to mount the bracket to the Fang. All fasteners used are M3. Some M3 washers could be used on the BLT mount if you find the M3x8 is too long. Caution: Be careful when securing the BLTouch mount to the Fang; turn the bolts slowly for a snug fit, but avoid over-tightening as it may cause the bolts to break through the Fang's inner wall.