Fang (fan) Duct for Tevo Tarantula Single Extruder Stock

thingiverse

Hi! It's a remix of the Fang for Dual Stock. I haven't tried it myself, so please leave comments! Cheers Print Settings Printer: Tevo Tarantula Rafts: Doesn't Matter Supports: No Resolution: 0.1 Infill: 25 Post-Printing print @ 0.1mm layer If printed at 0.1mm, no support is needed if you have at least three perimeters, with proper cooling and slow speed when you reach the high-angle overhang area, it will be nice enough to do the job. print @ 0.2mm layer At 0.2mm, you will need support, but be sure that NO SUPPORT are inside the duct; parameters should look like "from build platform only". It will be okay. Personally, I have printed the Dual with a 0.2mm layer up to 46mm and then 0.1mm to finish the print (I used two processes with Simplify3D; I don't know if possible with other slicers).