Fanatec Pedals Playseat Challenge Mount - CSL pedals

thingiverse

I liked the original design, but it didn't fit my CSL pedals that came with the Fanatec DD Pro. I managed to use the original part for the front position (closest to the chair) and I remixed the design for the rear position, so the pedals can be installed in the widest configuration. The hex hole turned out a bit small in my part, but the bolt (10.3 mm head diameter) I used fits perfectly, so I didn't bother changing it. Installation: ========= * Install rear mounts (remixed part) with the 16 mm bolt in the hex hole on the mount and washer and nut * Install front mounts (original part) with the 30 mm bolt in the hex hole on the mount, use the included Fanatec Hard Mount Spacers with washer. thread into the pedal base. * Install ZipTies in mounts * Tighten ZipTies around Playseat Challenge by pulling down then pulling up * Trim ZipTies Requirements: ============ * 1x 5mm Allen Key * 1x 10mm Wrench * 8x ZipTies 5mm * 2x M6x16mm Socket Head Bolt (low profile, so it doesn't protrude from mount) * 2x M6x30mm Socket Head Bolt * 4x M6 Washer * 2x M6 Nyloc Nut