Fanatec Formula Shifter Magnets

prusaprinters

<p>Shifter magnets for Fanatec Formula wheels. Available in two variants, 6mm magnets for light actuation, and 8mm magnets for heavy actuation.</p> <p><strong>Required Hardware:</strong><br/> (4) 6 x 2mm disk magnets OR (4) 8 x 2mm disk magnets<br/> (4) M3 x 5mm countersunk screws</p> <p><strong>Installation Instructions:</strong></p> <ol> <li>Remove shifter paddles.</li> <li>Use super glue to attach the magnets to the printed pieces. IMPORTANT: Make sure the magnet polarity is correct so that the printed pieces are attracted to each other. Wait for the glue to dry.</li> <li>Attach the flat printed piece to the wheel using the countersunk screws.</li> <li>Put the bent piece in place. The magnets should hold it in place.</li> <li>Re-install the shifter paddle using the original screws.</li> <li>Repeat for the other side.</li> </ol>