Fanatec CSW Hub spacer

thingiverse

This is a 2mm spacer that fits behind the pin stack on the wheel base side of most Fanatec bases. If you are having issues with disconnects when the wheel is being deflected, i.e. under lots of load in or out, this in conjunction with the metal quick release will help solve the problem. To install (written for CSW V2 wheelbase): 1. Remove back cover via 4x Hex head screws. 2. Disconnect fan attached to back cover. 3. Loosen PCB via bottom two screws. (Be very careful with it, it's delicate) 4. Remove steering wheel and loosen the 5 hex head screws in the hub adapter. 5. Disconnect electrical connector that attaches to the pin stack, the glue holding it to the PCB will need to be removed. 6. Remove hub adapter with pin stack and wiring from wheel base. 7. Install printed spacer between the black plastic pin stack and the metal hub adapter. 8. Reinstall is reverse of assembly. This spacer will increase the amount of pin engagement by 2mm, and therefore will make the wheel harder to completely install onto the wheel base. Make sure that the pins are entirely seated before tightening.