Fanatec CSP V3 Throttle Throw Limiters

thingiverse

What is this?: It's 4 cylinders in different heights, for easy adjustment on the throttle throw on your Fanatec CSP V3, so you'll have minimal wear and tear of the threads that holds the rod. All have the diameter of 13 mm. It also helps you blip the throttle on downshifts, especially if you have the Brake Performance Kit, since the throw is now decreased. How do I install it?: See this video first: https://www.youtube.com/watch?v=ASrEvzp7IMQ&t=29s Start at 0:29, then stop at 1:32. What you need to do now, is to screw the rod all the way in, until it is sitting tight (unlike the video), and then tighten the nuts, so the rod is in place, and minimal thread is visible. Now take the pedalbox, where the rod goes in to, and remove the plastic cylinder inside of it (can be a little tricky, I had to use the short side of an allen key to get it out). Insert one of the 3D printed limiters (start with 10 mm, and maybe with a little lithium grease on it) into the pedalbox, so it sits at the bottom. Insert the plastic cylinder again, so the rod doesn't scratch the pedalbox, when pressing the throttle. Assemble the rod with the spring back into the pedalbox, so it's sits on the lower stroke again. But don't screw the cap on yet! Try and see if you like the throw - if not, try with a smaller limiter, until you reach your desired throw. When satisfied, assemble it all back together. Note: 10 mm limiter is absolute. Anything higher, and you won't be able to install the pedalbox back onto the lower stroke again.