Fanatec Clubsport Formula Magnetic Shifter Upgrade

thingiverse

Been learning fusion 360 so I wanted to have a go at creating a set of magnetic shifter upgrades for my ClubSport Formula wheel rim. It's a Remix of https://www.thingiverse.com/thing:4053974 but redesigned and redrawn to shave off some mass and print time whilst maintaining structural integrity. I embossed the Fanatec 'F' into the back parts for this there is a left and right version which will need to be printed so it is the right way up on both sides when fitted. I have also included a blank one if you prefer that. Print with support to support the holes for the magnets underneath, you might get away without it if you have good bridging In addition to the print you will need 4x 10mm round magnets at around 5mm thick. Mine where just short at 4.73mm but the recess holes are 5mm deep. These will need to be glued in place. You can use shallower magnets but might need a bit of packing. You can use the included screws for the main part to fix it to the back of the wheel but you will need some slightly longer 10mm M3 screws for the part that fits on the shifter arm as this is now about 3mm thicker. Check out my other Sim Racing/Fanatec designs