Fanatec Clubsport Formula magnetic shifter

thingiverse

Here is the rewritten text: DIY magnetic shifter mod for Fanatec Clubsport Formula Rim created entirely from scratch in FreeCAD, inspired by amstudio's design. The upper section of my mod remains completely flat and appears to function effectively without any need for adjustment. I acknowledge that the fit of the two 10mm magnets could be improved upon further refinement, but I'm content with the current setup given my limited time constraints. For this project, a total of four round magnets measuring 10x3mm are required, evenly distributed on both sides. To secure part 2 in place, 16mm M3 screws will be used, while part 1 will be mounted using either 10 or 12mm M3 screws. My prints were completed without the use of supports and turned out well.