Fan with Wire Management - Max Micron and other Prusa i3

cults3d

Just installed advanced cable organization into my upgraded parts cooling fan enclosure.\n *Version without cable management if you prefer...* http://www.thingiverse.com/thing:1794658\n• Enhanced airflow over the standard unit as the fan duct is brought closer to the desired area, resulting in reduced general air circulation around the nozzle and heat block.\n• Better visibility of the nozzle with the duct tucked up near the carriage.\n• Small shield at the mouth of the duct reduces direct airflow at the nozzle tip.\n• Improved access for maintenance or troubleshooting compared to many modified shrouds that wrap around and obstruct the nozzle.\n• Added simple cable management coming off the head to prevent sagging and lower wire stress during movement.\n\n*Note- check your layer settings in the slicer, rotate the model on the build platform to have support material run front to back over side to side as it's much easier to remove from inside that way.*