Fan Shroud for Printrbot LC V2

thingiverse

I'm planning to fine-tune the airflow soon. This initial version is pretty functional, but I'm not counting on it being the final design. I printed this out and it works decently well so far. I just temporarily secured it in place. Unfortunately, a lot of air escapes from the side where the screws that keep the fan in get in the way though. To fix this issue, I'm going to remove most of the tabs and hold it in place with an elastic band instead. It also needs some added support as one of the corners broke off when I was removing it from the bed. Luckily, some acetone fixed that damage right away.