Fan Shroud for Bukobot v2

thingiverse

Attach a 40mm fan using a mount and blower-style shroud onto the Bukobot v2's x carriage. This design is suitable for single extruder models, utilizing one of the holes that dual extruders would usually block. Adapt it for dual extruder models if needed, then share your results with others. Update: The original upload lacked the fan mounting plate on the shroud. To assemble, use 6 M3 fasteners. Attach the shroud to the mount from inside and tighten it for intentional adjustment. Fasten a nut on the underside of the x-carriage plate's fork end hole. Secure the fan to the large end of the shroud with four fasteners, which will tighten into the plastic without nuts. Finally, slide the mount over the x-carriage plate, positioning the fastener in its notch on the front side and tightening it to restrict movement.